5J.JLV05.001 5J.JLT05.001 For BENQ Projector Lamp EH600 EW600 EX600
EX800ST
Product Parameter
| Part Numbers | 5J.JLV05.001 5J.JLT05.001 |
| Fittable projector models | For BENQ Projector Lamp EH600 EW600 EX600 EX800ST |
| Bulb Type | 200 W |
| Life time | 3000 -5000(Hours) |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Product Information
The BENQ 5J.JLV05.001 5J.JLT05.001 replacement lamps are
compatiable with EH600 EW600 EX600 projectors.The working hour time
is:3000-5000 hours,After repalcing our new lamps,the projector
performance can be the same of the new original one and improve the
effect of projection,and make you feel comfortable while using.
Connect the power
To ensure that the power supply meets the projector's requirements,
plug the projector's power cord into an electrical outlet.
Bulb warranty
Refer to the User Manual: Consult the user manual provided by the
projector manufacturer for specific instructions on lamp
replacement. The manual will provide detailed information on the
lamp type, installation procedure, and any additional precautions
specific to your projector model.
Allow Lamp to Cool: Projector lamps generate heat during operation.
It is crucial to allow the lamp to cool down completely before
attempting to replace it. This prevents the risk of burns or damage
to the new lamp.
Use Proper Tools: Prepare the necessary tools for the installation,
such as a screwdriver or lamp removal tool, as specified in the
user manual. Using the correct tools will ensure a secure and safe
installation.
Access the Lamp Compartment: Locate the lamp compartment on your
projector. The exact location may vary depending on the projector
model. Usually, it is accessible from the top or bottom of the
projector or through a side panel. Remove any screws or latches
that secure the compartment.
Remove the Old Lamp: Carefully detach the old lamp by following the
instructions provided in the user manual. In some cases, the lamp
may be held in place by screws or clips. Gently release the lamp
and disconnect any cables or connectors attached to it.
